Suote Hongfa Engineers Provide Professional Answers: What Are the Reasons the Briquetting Machine Cannot Form Properly During Production?

    Analysis of the causes when the Charcoal Machine-Briquetting Machine encounters failure to form or when fuel rods break off section by section during production:

    The first thing to check for this issue is whether the Briquetting Machine propeller is worn. If propeller wear is confirmed, it must be repaired. Repair method: Preheat the area of the propeller tip that needs surfacing welding until the temperature reaches about 200 degrees. Use wear-resistant welding rods to conduct surfacing welding, with the welding thickness exceeding the required thickness by 1-2mm. After welding, insert the propeller to a depth of more than three thread leads for cooling. Remove it after cooling to below 50 degrees, then grind and polish it on a silicon grinding wheel. The repaired propeller must not be bumped or struck; it should be stored carefully and kept ready for use.

The Charcoal Machine manufacturer - Suote Hongfa Machinery Factory designs new Charcoal Machine equipment with its own innovative concepts. The innovative Charcoal Machine equipment further improves the design process, introduces new ideas while eliminating outdated ones, increases production capacity, adds dust removal equipment, and reduces equipment noise. This meets the high cost-performance ratio Charcoal Machine equipment that customers have been seeking.